I have FWSM (version 6.1(2)F) on 6513 core switch. It's configured in routed mode without natting. I have enabled DHCP relay on it and it's working fine but I need to enable BOOTP also so I want to know if dhcp and bootp can work together or not?
please find below the configuration of the dhcp on the FWSM:
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...