Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Enable only RDP,SMTP,POP and VPN traffic

Hi All;

I have a 871 router on which i want to implemet a firewall for my internal users so that all protocols are blocked except Remote Desktop SMTP POP & VPN so only clients who want to use the above protocols can access my local IP range is 192.168.1.0

3 REPLIES

Re: Enable only RDP,SMTP,POP and VPN traffic

hello Imran,

You can configure basic firewall features wit standard/extended access-lists on the 871 firewall.. in your case, u can allow ports 25, 110, UPD 500, UDP 4500 etc on ACL's and apply it on the ethernet interface of the router.. a default "deny any" on the ACL will prevent any other traffic hitting the router.. you can have a look at this URL for the sample config:

http://cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a008045d275.html

you can also configure CBAC if required on the 871 routers.

Hope this helps. all the best. rate replies if found useful..

Raj

Re: Enable only RDP,SMTP,POP and VPN traffic

Agree with Raj, however the CBAC configuration is most suitable for traffic initiated from the inside. In your case the best option will be what Raj mentioned in the previous post regarding using access-list

New Member

Re: Enable only RDP,SMTP,POP and VPN traffic

thanks to both of you

256
Views
3
Helpful
3
Replies
CreatePlease to create content