Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

enabling a third interface

question is more cosmetic I guess but I'm trying to name a third interface and I get an error stating you cannot have more than 2 named non-management interfaces on your system. My other ASAs can do this with the excpetion of this one. We are all on 7.2(2) software. Any ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: enabling a third interface

Your firewall might be running in transparent mode. In this mode, you can only have 2 non-management interfaces.

ASA# show firewall

Firewall mode: Transparent

If you dont want your firewall in Transparent mode, you can change it to router mode using following command-

ASA(config)# no firewall transparent

Hope that helps.

Regards,

Vibhor.

2 REPLIES
Silver

Re: enabling a third interface

Your firewall might be running in transparent mode. In this mode, you can only have 2 non-management interfaces.

ASA# show firewall

Firewall mode: Transparent

If you dont want your firewall in Transparent mode, you can change it to router mode using following command-

ASA(config)# no firewall transparent

Hope that helps.

Regards,

Vibhor.

New Member

Re: enabling a third interface

That was it.

Thanks.

169
Views
0
Helpful
2
Replies