ERROR: Command Ignored, Configuration in progress...

mahesh18 · ‎01-31-2014

Hi Everone,

When i type sh run on ASA 5520

it gives error

Any fix other than reboot?

Regards

Mahesh

Jouni Forss · ‎01-31-2014

Hi,

Are we talking about a Failover pair or a single ASA?

I have only had this happen to me while more than one people are configuring the ASA at the same time.

Can you see any other users on the device at the moment?

show ssh sessions

show asdm sessions

Then again if this is a Multiple Context mode ASA then you would perhaps have to issue those commands on the Admin Context depending how the management connections are set up.

I would imagine though that in normal circumstances this should not be a problem for a long time.

- Jouni

mahesh18 · ‎01-31-2014

Hi Jouni,

This is failover pair.

Single context.

Currently no one is logged in except me.

Regards

Mahesh

mahesh18 · ‎02-01-2014

Hi Jouni,

Here is more info on the issue.

This ASA is acting as DHCP server for users.

Now it is not providing IP to the users.

Also users PC who have IP from ASA i am unable to ping their IP address.

First we thought it was bad cable from patch panel to user.

Then we unplug the failover cable from standby firewall after this i was able to run all the commands and users were

able to get the IP address from the ASA.

Seems it is synch issue between 2 ASA.

After this i put failover cable back to standby and we lost access to primary firewall and our internet was not working.

Then we shutdwon the standby ASA and reboot the Primary ASA then everything was back to normal.

Currently standby ASA is standalone and not connecting to anything.

When i power on the standby ASA all hardware looks ok and is up and running.

Regards

Mahesh

Message was edited by: mahesh parmar