Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ERROR when I try to enable Top usage Status

When I try to enable Top Ten Sources I get the following error.

[ERROR] threat-detection statistics host number-of-rate 0

threat-detection statistics hosts number-of-rate 0

% Invalid dectected at '^' marker

ASA 5520

ASA 8.0(4)

ASDM 6.1(5)

2 REPLIES
New Member

Re: ERROR when I try to enable Top usage Status

I was able to implement this via the ASDM GUI in the "configuration...threat detection" screen. From looking at your CLI command it would appear that 0 is not an option, you need to use an integer value between 1 and 3.

New Member

Re: ERROR when I try to enable Top usage Status

Hi,

1. try to use the  command #threat-detection statistics in CLI mode.

2, save the config disconnect and reconnect ASDM.

I have not met this situation, found a similar senario and resolution on the web.

hepe it works

Yang

1477
Views
4
Helpful
2
Replies