Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Error when using wr mem

Hi everyone,

I got a strange problem, on my FWSM, when i use the command wr mem i get a error, any one seen this befor ??

ipmsap/act# wr mem

Building configuration...

Cryptochecksum: xxx

%Error copying flash:/startup-config (Cannot overwrite image (asdm) file with ascii text file.)

Error executing command

[FAILED]

ipmsap/act#

The configuration i don just after session slot X processor 1

Cheers

Peter

3 REPLIES
Cisco Employee

Re: Error when using wr mem

is this in failover ?

if yes,

issue a wr erase first and afterwards " wr mem "

please rate if this helps

Regards,

Sushil

New Member

Re: Error when using wr mem

Yes the firewall is one part of failover setup, but it is the primary in the failover,

the error was first seen after a password recovery attemt.

cheers

Peter

Cisco Employee

Re: Error when using wr mem

please make the other unit primary,do a wr erase on this one.one the config. is replicated,then do a " wr mem " .

hth

Sushil

Cisco TAC

402
Views
0
Helpful
3
Replies
CreatePlease to create content