Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Etherchannel on ASA

Hello

Is there a possibility to aggregate multiple ports into one logical channel on the Cisco ASA ?

Thank your advance

Regards

Lucas

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Etherchannel on ASA

This is supported as of 8.4.1.

EtherChannel support (ASA 5510 and higher)

You can configure up to 48 802.3ad EtherChannels of eight active interfaces each.

Note You  cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM  in slot 1 on the ASA 5550, as part of an EtherChannel.

We introduced the following commands: channel-group, lacp port-priority, interface port-channel, lacp max-bundle, port-channel min-bundle, port-channel load-balance, lacp system-priority, clear lacp counters, show lacp, show port-channel.

http://www.cisco.com/en/US/docs/security/asa/asa84/release/notes/asarn84.html#wp432043

3 REPLIES

Re: Etherchannel on ASA

etherchannel is not yet supported on ASA

Bronze

Re: Etherchannel on ASA

This is supported as of 8.4.1.

EtherChannel support (ASA 5510 and higher)

You can configure up to 48 802.3ad EtherChannels of eight active interfaces each.

Note You  cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM  in slot 1 on the ASA 5550, as part of an EtherChannel.

We introduced the following commands: channel-group, lacp port-priority, interface port-channel, lacp max-bundle, port-channel min-bundle, port-channel load-balance, lacp system-priority, clear lacp counters, show lacp, show port-channel.

http://www.cisco.com/en/US/docs/security/asa/asa84/release/notes/asarn84.html#wp432043

New Member

Re: Etherchannel on ASA

Ok, thank you for this info.

4541
Views
4
Helpful
3
Replies