Etherchannel support for ASA 5585X

[prabhanjan_hb]

Hi there , Just trying to find out which all versions of ASA 5585X can support etherchannel features .

Thanks

Prabs

[Jouni Forss · Accepted solution]

Hi,

To my understanding any ASA (except ASA5505) from 8.4(1) onwards can use EthernetChannel

Quote from Cisco document

Interface Features
EtherChannel support (ASA 5510 and higher)
You can configure up to 48 802.3ad EtherChannels of eight active interfaces each.
Note You cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM in slot 1 on the ASA 5550, as part of an EtherChannel.
We introduced the following commands: channel-group, lacp port-priority, interface port-channel, lacp max-bundle, port-channel min-bundle, port-channel load-balance, lacp system-priority, clear lacp counters, show lacp, show port-channel.
We introduced or modified the following screens:
Configuration > Device Setup > Interfaces
Configuration > Device Setup > Interfaces > Add/Edit EtherChannel Interface
Configuration > Device Setup > Interfaces > Add/Edit Interface
Configuration > Device Setup > EtherChannel 

Source:

http://www.cisco.com/en/US/docs/security/asa/roadmap/asa_new_features.html#wp43273

Here is also a link to the "interface" command for Etherchannel

http://www.cisco.com/en/US/docs/security/asa/command-reference/i3.html#wp1932200

Hope this helps

- Jouni

[prabhanjan_hb]

Thank You Jouni

[Jouni Forss]

Hi,

No problem,

Please do remember to mark the reply as the correct answer if it answered your question.

- Jouni