Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Ethernet port 1 could not initiallid

Hi

I format my pix 535 flash. then after I enter ROMMON mode. when i upgrade MY image first I give command

'interface 1' then message come Ethernet ===port 1 could not initiallid==

so i can not give ip address .

now how can solve this problem .

Thanks

Biplob

1 REPLY
Silver

Re: Ethernet port 1 could not initiallid

Is it a gig or Fa interface?

The PIX cannot initialize a Gigabit Ethernet interface from monitor or boothelper mode. Use a Fast Ethernet or Token Ring interface instead.

Thanks,

Chad

114
Views
0
Helpful
1
Replies
CreatePlease to create content