I'm trying to add an access-list rule to allow internal servers to connect an outside host on a asa 5540. The hostname translates to multiple ip's. Normally I just lookup the ip address or one of the ip's the hostname translates too and use that in the access-list as the host.
For some reason the actual ip's, which are a few, are not always available so using a specific ip sometimes does not work, thus the reason I have to use the hostname instead of the ip. I have 2 hostnames. www.hostname.com and subdomain.hostname.com.
This is how I normally add these rules (the ip addresses are fictive):
Thanks for your reply. Indeed the asa does not allow me to use a hostname. The question is, how can I still make this work without going for 'any' or adding all the possible ip's it might translate too.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...