Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Fail to Wire in Cisco Pix 525 (on Transparent Firewall mode)??

Is possible configure fail to wire in a PIX working on Transparent firewall mode, to allow pass all the traffic in case of shutdown o reset the PIX?

Thanks

Best regards.

Everyone's tags (2)
3 REPLIES
Cisco Employee

Re: Fail to Wire in Cisco Pix 525 (on Transparent Firewall mode)

Yes, failover is possible for PIX 525 in transparent mode.

For Active/Standby failover, here is the configuration guide:

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html#wp1058096

Hope that helps.

Re: Fail to Wire in Cisco Pix 525 (on Transparent Firewall mode)

I want say, with a single PIX, if I turn it off or restart it, if PIX allows traffic to pass through it like a cable

Thanks

Cisco Employee

Re: Fail to Wire in Cisco Pix 525 (on Transparent Firewall mode)

OK, thanks for the clarification.

The answer is no, if you reset the PIX firewall or turn it off, it will not pass any traffic at all.

1177
Views
0
Helpful
3
Replies