Failover active/standby

[Ivan Kurguzov]

Hello. There are two Cisco devices: asa5512 and asa5510. Tell me whether it is possible to organize a failover active / standby using these devices. If this is not possible, tell me if there are any other possibilities for automatic backup.

[Vibhor Amrodia]

Hi,

Fail over between different Hardware Models is not possible.

Thanks and Regards,

Vibhor Amrodia

[Vibhor Amrodia · Accepted solution]

If by Backup , you mean hardware Redundancy , it would not be possible.

You can run the same configuration on both the devices and if one fails , you can manually replace it with the other one.

Thanks and Regards,

Vibhor Amrodia

[Ivan Kurguzov]

Thanks.