Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Failover active/standby

Hello. There are two Cisco devices: asa5512 and asa5510. Tell me whether it is possible to organize a failover active / standby using these devices. If this is not possible, tell me if there are any other possibilities for automatic backup.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

If by Backup , you mean

If by Backup , you mean hardware Redundancy , it would not be possible.

You can run the same configuration on both the devices and if one fails , you can manually replace it with the other one.

Thanks and Regards,

Vibhor Amrodia

3 REPLIES
Cisco Employee

Hi,Fail over between

Hi,

Fail over between different Hardware Models is not possible.

Thanks and Regards,

Vibhor Amrodia

Cisco Employee

If by Backup , you mean

If by Backup , you mean hardware Redundancy , it would not be possible.

You can run the same configuration on both the devices and if one fails , you can manually replace it with the other one.

Thanks and Regards,

Vibhor Amrodia

Community Member

Thanks.

Thanks.

86
Views
0
Helpful
3
Replies
CreatePlease to create content