Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failover config on a PIX 525 7.2(1)

Hello,

I have 2 PIX 525 running version 7.2(1). I have it setup a serial cable failover. The problem is when I run a show fail command it list that the outside interface is up and running and failover is working fine. but on the other 2 interfaces, inside and DMZ next to the ip address it shows "(waiting)" . I have check the switch ports that these 2 itnerfaces are plugged into and there are all set to auto, they all match. What else can I check?

Thanks for all and any information

1 REPLY

Re: Failover config on a PIX 525 7.2(1)

Make sure they have layer two connectivity.

Such as inside interface on both PIX should have a layer 2 connectivity. DMZ interface on both PIX should have a layer 2 connectivity.

1. port on switch and PIX should be in up/up state.

2. make sure the ports on switch are assigned to the right vlan.

143
Views
0
Helpful
1
Replies