Failover link requirements for Asa5580 with 10G interfaces
If I use bundle ASA5580-40-10G-K9 in failover configuration should I use 10G interface for stateful failover link or 1G will be enough? Traffic on data interfaces will exceed 1G. Is a Etherchannel option available on ASA for failover link?
If you use the failover link as the Stateful Failover link, you should use the fastest Ethernet interface available. If you experience performance problems on that interface, consider dedicating a separate interface for the Stateful Failover interface.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...