Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Failover or redundancy with ASA 5510

Hello Group.

We have a ASA 5510 and are in the process of replacing a watchguard firewall on our network. We have the optional CSM and the ASA has 4 ports, 3 which are active. We have one port that is set up for the inside and would like to have the other two set up for two different ISPs. Has anyone set up the ASA like this and if so any advice that you can give. We were going to do this with a router, but we found out that the two ISP's (as I hear most are) will only route their own traffic.

1 REPLY
jim
New Member

Re: Failover or redundancy with ASA 5510

If you setup in context mode this shouldnt be a problem.

Just "allocate-interface (interface)" each interface you want in each firewall instance.

286
Views
0
Helpful
1
Replies