Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failover traffic sync problem

Hi,

If I permit udp traffic specifically in nat0 statement facing problem with configuration sync in failover.

Instead if I permit tcp or ip in nat0 statement every thing works fine.

What might be the problem?

Regards..

1 REPLY
Bronze

Re: Failover traffic sync problem

You may try using the "nat-control" statement. The nat-control command on the PIX/ASA specifies that all traffic through the firewall must have a specific translation entry (nat statement with a matching global or a static statement) for that traffic to pass through the firewall.

91
Views
0
Helpful
1
Replies