Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

failover using management interface on asa

hi all i am trying to setup asa failover using the management interface.

asa1

int e0/0

nameif inside

ip add 10.1.1.1 255.255.255.0 standy 10.1.1.2

no sh

int e0/1

nameif outside

ip add 1.1.1.1 255.255.255.0 standy 1.1.1.2

no sh

int m0/0

no sh

no management-only

int m0/0.1

no sh

vlan 30

no management-only

failover

failover lan unit primary

failover lan interface failover m0/0.1

failover interface ip failover 172.16.1.1 255.255.255.0 standby 172.16.1.2

failover key cisco

failover link failover m0/0.1

asa2

int m0/0

no sh

no management-only

int m0/0.1

no sh

vlan 30

no management-only

failover

failover lan unit secondary

failover lan interface failover m0/0.1

failover interface ip failover 172.16.1.1 255.255.255.0 standby 172.16.1.2

failover key cisco

failover link failover m0/0.1

the asa 's are not getting failover messages from each other.

no response from mate

finally both the asa's are becoming active.

is failover not suppose to run on the management interface even if i have made it a data interface and using it dedicately for failover.

can someone pls help me on this.,

waiting for reply.

regards

sebastan

2 REPLIES
New Member

Re: failover using management interface on asa

Hi sebastan,

Management interface should not be used for the failover feature.

Infact, It will not allow the traffic to pass through it. we can use this interface for managing the device over the network.

Use any dedicated ethernet port.

Hope it helps.

--Jaffer

New Member

Re: failover using management interface on asa

We are using management interface as failover link and it's working fine. The only thing is that it's only 100MB connection comapre to all GIG interfaces.

1216
Views
0
Helpful
2
Replies
CreatePlease to create content