Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Foreign address 0.0.0.0:* under show asp table socket

Hi everyone,

When i ssh to ASA  and ran the command

show asp table socket  i see below

show asp table socket

show asp table socket


Protocol  Socket    Local Address               Foreign Address         State
SSL       000035c4  192.168.100.3:443            0.0.0.0:*               LISTEN
TCP       00005d5c  192.168.100.3:22             0.0.0.0:*               LISTEN
TCP       00006f5c  192.168.101.3:22             0.0.0.0:*               LISTEN
TCP       00009314  192.168.2.3:22               0.0.0.0:*               LISTEN
TCP       2f9ea0f4  192.168.101.3:22             192.16.3.5:55746        ESTAB

Where  under foreign address i can see  my pc address 192.168.3.5.

Need to know why other foreign address are showed as 0.0.0.0*??

will  by default ASA  will always show 4  foreign address as 0.0.0.0*?

Regards

Mahesh

1 ACCEPTED SOLUTION

Accepted Solutions

Foreign address 0.0.0.0:* under show asp table socket

Hi,

It seems that you are opening port 443 and 22 on your ASA. This can be checked by using below commands:

- show run http

- show run ssh

I don't think by default it will show any open port. This is because by default the behaviour on ASA is that all ports are close and you have to open port that you want to open/use. Which on router, it's the opposite, by default all ports are open.

HTH,

2 REPLIES

Foreign address 0.0.0.0:* under show asp table socket

Hi,

It seems that you are opening port 443 and 22 on your ASA. This can be checked by using below commands:

- show run http

- show run ssh

I don't think by default it will show any open port. This is because by default the behaviour on ASA is that all ports are close and you have to open port that you want to open/use. Which on router, it's the opposite, by default all ports are open.

HTH,

Community Member

Foreign address 0.0.0.0:* under show asp table socket


Hi Rudy,

Regards

MAhesh

298
Views
0
Helpful
2
Replies
CreatePlease to create content