Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Forwarding Netbios names over point-to-point connection and Pix

Dears

We have two networks connected over ADSL point-to-point connection(actually one side is MetroEthernet). Lets say A and B networks. On both sides there are Pix 501 and Pix515 respectively. There are computers located in A with i.e. 10.0.0.1/24, 10.0.0.2/24.. And in network B there is also a computer with the same subnet configuration. (i.e. 10.0.0.3/24), all computers do not have gateway addresses congfigured and they try to communicate each other over NetBIOS. So What i need to try is to connect the PC in B to A over this firewalls. Please note that it is almost impossible to change IP configuration of PCs. Is this possible??

Best Regards,

Deniz

3 REPLIES
Silver

Re: Forwarding Netbios names over point-to-point connection and

What version of software does your pix box run?

New Member

Re: Forwarding Netbios names over point-to-point connection and

6.3.1 and 6.3.5

best Regards,

Deniz

Re: Forwarding Netbios names over point-to-point connection and

Hi,

As far as I know 6.x will not support the transparent firewall feature from 7.x.

The way to do it is with routers and GRE tunnel.

Please rate if this helped.

Regards,

Daniel

129
Views
0
Helpful
3
Replies
CreatePlease login to create content