Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FTP Through a 2800

I am wanting to swap a 2600 out with a 2800.

We do application hosting here and one client is behind the said 2600. They do FTP transactions and a few months back when they started this process we fixed the issue by adding the following commands onto the 2600

ip inspect name Ethernet_0_0 ftp

and then

intf 0/0

ip inspect Ethernet_0_0 in

Intf 1/0

ip inspect Ethernet_0_0 in

I copied the config to the 2800 and made adjustments were the intfa names changed and all works great with the exception of FTP. 2600 is back in place until I can get 2800 working.


Brent Austin

New Member

Re: FTP Through a 2800

Did you check that 2800 IOS has the same features as the IOS in the 2600?

New Member

Re: FTP Through a 2800

Yes, was done to make it as seamless as possible for all clients...

Unfortunately, it does not do the trick.

Is there a way to just allow ftp to and from that is easier than the one used?


New Member

Re: FTP Through a 2800

Could you post the 2800 sh ver output and config?