Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

FW Module Design Failover over 3 modules its possible ?

I need know if possible the configuration with FWM (version 3.1(4)in squeme Active - Standby - Standy Or other state last module

2 REPLIES
Hall of Fame Super Blue

Re: FW Module Design Failover over 3 modules its possible ?

Armando

No this is not possible, you can only use pair in failover.

http://www.cisco.com/en/US/docs/security/fwsm/fwsm31/configuration/guide/fail_f.html#wp1041883

Jon

Community Member

Re: FW Module Design Failover over 3 modules its possible ?

Jon

In my case ,the third fwm intsalled in DC secondary .I required backup over two fwm in the data center primary.

Could please the mentioned valid squeme ?

Best regards

133
Views
0
Helpful
2
Replies
CreatePlease to create content