Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

FWSM 3.1.5 not passing traffic for Virtual IP Addresses on Load Balancer

Dear All,

I am facing this problem in one of my customers network.Two Core Switch Catalyst 6513 is having FWSM and ACE Module in failover mode. On ACE one server farm is created. VIP of this server farm is reachable from FWSM context as it is laying on inside interface of FWSM but not rechable from any network behind outside interface of FWSM. While real servers in same subnet are reachable as ACE context is in bridge mode.

Looking forward for your valuable suggestions on the same.

I am open if you need further diagram and config on the same.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: FWSM 3.1.5 not passing traffic for Virtual IP Addresses on L

This document explains the procedures you can use in order to resolve problems with the Firewall Service Module (FWSM) failover configuration.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a0080965dec.shtml

2 REPLIES
Bronze

Re: FWSM 3.1.5 not passing traffic for Virtual IP Addresses on L

This document explains the procedures you can use in order to resolve problems with the Firewall Service Module (FWSM) failover configuration.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a0080965dec.shtml

New Member

Re: FWSM 3.1.5 not passing traffic for Virtual IP Addresses on L

Hi,

Thanks for your response. This problem is fixed with identity NAT.

160
Views
0
Helpful
2
Replies
СоздатьДля создания публикации, пожалуйста в систему