Hi friends, I was wondering if any one of you have faced simillar problem that I am facing.
I have 2 FWSM's 3.1(5), in two seperate 6509's running native IOS 12.2(18)SXF7.
I have created 2 groups with one active on each switch. Problem is they are always active on the primary FWSM. Group 2 configured to stay active on secondary FWSM doesn't preempts. and likewise if you take primary down then all contexts are failed over to secondary but again wihtout any preemption for group 1 from Primary.
I checked wht ever I could remember like switch vlan's, sync between them, ping each other.
is there any body out there who has been throught this ?..
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...