Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

fwsm - active/standby - "Vlan configuration mismatch between peers"

Hi,

A FWSM pair fall in to active active sittuation due to a vlan configuration mismatch. What would be the best way to synchronize configurations and return to the normal active/standbay? There is a new vlan on the primary fwsm and at present both are in active state.

Thank you in advance.

Zdravko

1 REPLY
Super Bronze

fwsm - active/standby - "Vlan configuration mismatch between pee

Hi,

To my understanding the FWSMs (even though both active) have identical configurations?

Have you perhaps done so that on the core switch you have only issued the "firewall vlan-group only on the primary core device (to which the FWSM is attached) and not the secondary core device?

The only time I have witnessed the same situation is when configuring a new customer link and I have only configured the primary unit (and about to configure the same on the standby unit)

Hope it helps, not sure if the above was what you meant.

- Jouni

631
Views
0
Helpful
1
Replies
CreatePlease to create content