Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM: capture command not working on V3.2(1)

I know that this was supposed to be fixed in 3.1, but I can't seem to get any

results when running standard capture commands on any interface even though I'm sure traffic is flowing. This is a FWSM in a Cat 6500, running IOS 12.2(18)

in multiple context mode. I even tried a capture on the managment interface in the admin context and saw no capture data even when I used an ssh session to log into the admin context.

This is a very useful debugging tool, I hope someone can tell me that I'm missing something here.

thanks,

Peter

1 REPLY
New Member

Re: FWSM: capture command not working on V3.2(1)

Figured it out, thought I'd post the results because I hadn't seen this requirement before. Those interested can check out

http://www.cisco.com/en/US/partner/docs/security/fwsm/fwsm32/configuration/guide/troubl_f.html#wp1068063

where it pretty clearly says that using an access list is required in order to get anything captured. I use a permit ip any any

as a test and it worked just fine.

Don't know if 3.1 required this as well and I just missed it somehow.

thanks,

Peter

113
Views
0
Helpful
1
Replies