I have configured Primary FWSM failover with statelink and configured Secondary FWSM failover with same primary ip.started detecting Mate.failover is configured correctly..Then i have stated to configure normal config link nameif, ip address..its started replicating the same to Secondary FWSM..when i though of doing Failover test i have reset the Primary then gave sh fail in primary..its is showing like bellow
ABCFWSM001# sh fail
Failover Off (pseudo-Standby)
Failover unit Primary
Failover LAN Interface FWFAILOVER Vlan 99
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 15 seconds
Interface Policy 50%
Monitored Interfaces 0 of 250 maximum
but Secondary is in Active state..Primary status is disabled.
Kindly advice me how to start the config(like primary normal config first and Secondary is next..then on failover)...What's the correct procedure to go..and provide me the steps for failover config also..Thanks in advance
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...