Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM - delete access-list

Hi

I recently upgraded our FWSM from 2.3 to 3.1

Previously if I wanted to make multiple changes to an access list I would edit it offline and then re-upload after using the "no access-list WHATEVER" command to delete the old version.

However this command is not available on 3.1 - how then can I delete an access-list??

OK the newer image does allow you to use line-numbers to edit ACLs but this is no substitute for being able to edit offline. Any ideas?

Liam.

1 REPLY
New Member

Re: FWSM - delete access-list

ok - found it. its "clear configure access-list WHATEVER"

not that this is particularly obvious from the configuration guide or the command reference (indeed the troubleshooting section of the conf guide specifically says to use "no access-list")

255
Views
0
Helpful
1
Replies
CreatePlease to create content