FWSM DHCP-relay configuration triggered a failover !
I have two FWSM in multiple contexts mode and working as active/standby.
I configured DHCP relay on one context interface (DMZ), using the ASDM graphical interface. When applying the configuration, a failover occured, which led to loss of connectivity between inside and outside for about 20 seconds.
Is it normal that the activation of the DHCP relay function is disruptive ?
More generally, is there an existing list of commands that are not transparently applied in a FWSM ?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...