Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

FWSM: DHCPD

DHCPD is not configuring on failover FWSM. All other config is syncing between both FWSM.

dhcpd address 10.27.0.10-10.27.1.9 INSIDE

dhcpd lease 3600

dhcpd ping_timeout 50

dhcpd option 150 ip 10.27.2.10 10.27.2.11

dhcpd enable INSIDE

FWSM Firewall Version 4.0(7)

Device Manager Version 6.1(5)F

Please advise.

1 REPLY
Cisco Employee

Re: FWSM: DHCPD

Have you tried a "write standby" on the active unit or reloading the standby?

If neither helps, check "show console-output" on the standby.

If that does not provide any clue, open a TAC case as it sounds like a bug.

220
Views
0
Helpful
1
Replies
CreatePlease to create content