Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FWSM failover: Context State after failover is FAILED,why ?

Hi every one,we have two FWSM in our 6509 switches,fwsm's are in multiple context mode and are configured for active/active.we have two context= admin and public.here is detail:

FWSM-1=admin(active) public(standby)

FWSM-2=admin(standby) public(active)

so recently for some reason we had failover for FWSM-1 but now every thing is normal except that in fwsm-1 admin is active that shuld be BUT context public which should be in standby-ready is in FAILED state,why?is this for last failover? and now if fwsm-2 fails what would happen?fwsm-1 wont take active rule? consider this that in fwsm-1 context admin monitored interfaces are normal but in fwsm-1 context public all monitored interfaces are in failed state just as context state?

1 REPLY
New Member

Re: FWSM failover: Context State after failover is FAILED,why ?

please,i need your advise!

261
Views
0
Helpful
1
Replies