FWSM Failover Host Secondary is Active and Primary is Damage
I have a couple of FWSM Version 2.3 (4) in failover Active/standby, a few years ago when our service provider make an upgrade change the failover role and our Primary change to secondary, but something happend that we promoted the secondary as an active, today i notice that my Primary (standby) fail i can´t access for any way, i don´t see any choices just reset the FWSM, but:
What happend when the primary finished to boot, it is going to take the control and be the Active
I don´t know the difference between the configuration files, because i don´t know how long the FWSM is down
What cai i do to keep the current configuration, without affect all the contexts
This is the configuration and the sh fail
failover failover lan unit secondary failover lan interface fover_lnk vlan 499 failover polltime unit 1 holdtime 15 failover polltime interface 15 failover interface-policy 1 failover link fover_lnk vlan 499 failover interface ip fover_lnk 172.16.0.1 255.255.255.252 standby 172.16.0.2 arp timeout 14400
idcfw1-mty1# sh fail Failover On Failover unit Secondary Failover LAN Interface fover_lnk Vlan 499 Unit Poll frequency 1 seconds, holdtime 15 seconds Interface Poll frequency 15 seconds Interface Policy 1 Monitored Interfaces 50 of 250 maximum Config sync: active Last Failover at: 06:12:23 Nov 19 2008
This host: Secondary - Active Active time: 54504950 (sec) sorteotec Interface inside202 (192.168.100.2): Normal (Waiting) sorteotec Interface outside103 (184.108.40.206): Normal (Waiting)
Other host: Primary - Failed Active time: 42702 (sec) sorteotec Interface inside202 (192.168.100.1): Normal sorteotec Interface outside103 (220.127.116.11): Normal
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...