Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FWSM Failover Pair Upgrade

I was told that it was necessary to completely disable a failover configuration before seperately reloading the pair to boot into the new software.

However, I'm not seeing that in any of the documentation...which simply says to install the software, make the secondary active, reload the primary, etc.

Is this correct that the failover has to be disabled?

Thanks.

  • Firewalling
1 REPLY
Hall of Fame Super Silver

FWSM Failover Pair Upgrade

My experience is that the Cisco documentation is correct (i.e., it is NOT necessary to disable failover).

I (carefully) followed the procedure described here successfully.

284
Views
0
Helpful
1
Replies
This widget could not be displayed.