I 2 6506 switches, that are configured as Active/Standby. but the problem I am facing is that the running config on both FWSM are in Sync on both FWSM, the startup config on the active is the same as the running, but the startup config on the Standby is has 1000 lines missing compare to the running Config. Can somebody help? as I have save the config on the active and still having issues....please help?
Have you tried issuing the 'write standby' command on the Active unit to see if the configurations will sync up?
Also, I would suggest looking to see if there are there any syslogs generated during a time when the pair is trying to sync their configs. You can also take a look at the output of 'debug fover sync' when the pair is syncing and 'show failover' to see if anything stands out there that may help you point to the problem.
So if you try a 'write memory' on the Standby unit, do the startup and running configs become in sync again? Do you get any error messages when trying to do this? Maybe there is a problem with the flash that is preventing you from storing the startup config?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...