As Kureli says, the 2 are not really related. Bear in mind if you are firewalling between the voice and data vlans then you won't have L3 SVI's for these vlans on the 6500 switches anymore so HSRP for these vlans is not relevant.
The L3 interfaces for the voice and data vlans will have to be migrated to the FWSM.
As the FWSM will only being installed next week I'm just planning this install. I'm new to fwsms!!
Still quite confused about replacing HSRP running between the core switches, can you give me an example on how to configure this for the DATA & Voice VLANS on both fwsms. There must be full redundancy on both core switches.
You need 1 or 2 vlans pushed down for failover interface failover state
There are two main issues in the config.
1. There is no access-list applied on the interface. To allow any traffic to enter the FWSM, you must attach an inbound access list to an interface; otherwise, the FWSM automatically drops all traffic that enters that interface.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...