Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

FWSM in Transparent mode help

Hi all,

i am actually designing for a new solution based on 6509 Switch with FWSM module, here is what i have :

6500+fwsm.jpg

FWSM will be used in Transparent mode with two bridge group : 1 , 2 as mentioned on the image, i wonder if this is a correct deisgn or not, is this will work with no probleme with these two trunk links ?

i've seen on the guidelines of this url :

http://www.cisco.com/en/US/docs/security/fwsm/fwsm22/configuration/guide/fwmode.html#wp1184961

"The transparent FWSM uses an inside interface and an outside interface only. "

is it applicable in my case,

any other information will be welcome.

Thanks for help

252
Views
0
Helpful
0
Replies
CreatePlease to create content