The failover link uses a special VLAN interface that you do not configure as a normal networking interface; rather, it exists only for failover communications. This VLAN should only be used for the failover link (and optionally for the state link). Sharing the failover link VLAN with any other VLANs can cause intermittent traffic problems and ping and ARP failures. For inter-chassis failover, use dedicated interfaces on the switch for the failover link.
On systems running in multiple context mode, the failover link resides in the system context. This interface and the state link, if used, are the only interfaces that you can configure in the system context. All other interfaces are allocated to and configured from within security contexts.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...