Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FWSM & IP Sec VPN module configuration

Hi All,

we have a 7609 chassis where we have installed the FWSM module and IPsec VPN module.

we would like to configure a Site to Site VPN.

how do we do that now ?

Below is the VLAN interface

configuration (outside)on the fwsm

interface Vlan601

description INTERNET CONNECTION

nameif INTERNET

security-level 0

ip address x.x.x.x 255.255.255.248 standby x.x.x.x

thanks.

1 REPLY
New Member

Re: FWSM & IP Sec VPN module configuration

First be sure that you are not using Security Contexts.

Other than that, the L2L VPn setup is exactly the same as it is on an Pix or an ASA.

Define your isakmp policies, specify the VPN interface, transform set, crypto map, tunnel group, and no nats (if necessary).

You can use this as a guide:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080950890.shtml

111
Views
0
Helpful
1
Replies