Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM Memory Management Ver 3.1(5)

Hi

We have a FWSM running ver 3.1(5). We are running into memory problems on one of the contexts/partitions. Apart from using the

resource acl-partition <number-of-partitions>

command, is there any way of manually reconfiguring more memory to the particular context which requires the most?

Is there a good webpage with memory management advice for the FWSM?

Thanks

Senan

3 REPLIES

Re: FWSM Memory Management Ver 3.1(5)

You can use the "allocate-acl-partition" in the system context to 'dedicate' a memory partition to a particular context. This was this context has 'exclusive' access to this partition, have a look at:

http://www.cisco.com/en/US/docs/security/fwsm/fwsm31/configuration/guide/contxt_f.html#wp1126565

Regards

Farrukh

New Member

Re: FWSM Memory Management Ver 3.1(5)

Thanks Farrukh

The context is already in its own memory partition but I'll configure it exclusive now as well.

Thanks

Senan

Re: FWSM Memory Management Ver 3.1(5)

I'm sorry this is the only alternate I know of. If you add multiple contexts then they start sharing the partitions. This way you can at least guarantee one partition for this high utilization context.

Regards

Farrukh

156
Views
0
Helpful
3
Replies