Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM NAT Error

After I finished my configuration for my FWSM, I cannot access to the outside. what do i wrong?

FWSM/pri/act(config)# ping

Interface: ext

Target IP address: 194.25.2.129

Repeat count: [5]

Datagram size: [100]

Timeout in seconds: [2]

Extended commands [n]:

Sweep range of sizes [n]:

Sending 5, 100-byte ICMP Echos to 194.25.2.129, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 10/12/20 ms

FWSM/pri/act(config)#

FWSM/pri/act(config)# ping

Interface: tr_fwsm

Target IP address: 194.25.2.129

Repeat count: [5]

Datagram size: [100]

Timeout in seconds: [2]

Extended commands [n]:

Sweep range of sizes [n]:

Sending 5, 100-byte ICMP Echos to 194.25.2.129, timeout is 2 seconds:

?????

Success rate is 0 percent (0/5)

Everyone's tags (5)
1 REPLY
Cisco Employee

FWSM NAT Error

Seems like you are ping ing it with incorrect interface.

Your first attempt uses "ext" interface, and the unsuccessful attempt is using "tr_fwsm" interface.

344
Views
0
Helpful
1
Replies
CreatePlease to create content