cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
539
Views
0
Helpful
1
Replies

FWSM NAT Error

alexander.cario
Level 1
Level 1

After I finished my configuration for my FWSM, I cannot access to the outside. what do i wrong?

FWSM/pri/act(config)# ping

Interface: ext

Target IP address: 194.25.2.129

Repeat count: [5]

Datagram size: [100]

Timeout in seconds: [2]

Extended commands [n]:

Sweep range of sizes [n]:

Sending 5, 100-byte ICMP Echos to 194.25.2.129, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 10/12/20 ms

FWSM/pri/act(config)#

FWSM/pri/act(config)# ping

Interface: tr_fwsm

Target IP address: 194.25.2.129

Repeat count: [5]

Datagram size: [100]

Timeout in seconds: [2]

Extended commands [n]:

Sweep range of sizes [n]:

Sending 5, 100-byte ICMP Echos to 194.25.2.129, timeout is 2 seconds:

?????

Success rate is 0 percent (0/5)

1 Reply 1

Jennifer Halim
Cisco Employee
Cisco Employee

Seems like you are ping ing it with incorrect interface.

Your first attempt uses "ext" interface, and the unsuccessful attempt is using "tr_fwsm" interface.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: