Hi,
I have a FWSM with OSPF with two neighbors all in area 1, it learn inter area and external routes from one of him, my problem is that the FWSM not flood this routes to other neighbor. I make a show ospf and i see the fwsm as ASBR and i dont understand why.
I paste the output from sh run router, show ospf and show ospf neighbor commands
FWSM-USERS# sh run router
!
router ospf 1
network 10.2.89.0 255.255.255.0 area 1
network 10.2.244.0 255.255.252.0 area 1
network 10.2.252.16 255.255.255.248 area 1
network 10.2.252.40 255.255.255.248 area 1
router-id 10.2.252.42
log-adj-changes
!
FWSM-USERS# sh ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
10.2.252.17 1 FULL/BDR 0:00:38 10.2.252.17 svi
10.2.252.41 1 FULL/DR 0:00:30 10.2.252.41 svi_vrf
FWSM-USERS# sh ospf
Routing Process "ospf 1" with ID 10.2.252.42 and Domain ID 0.0.0.1
Supports only single TOS(TOS0) routes
Does not support opaque LSA
It is an autonomous system boundary router
Redistributing External Routes from,
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
Number of external LSA 7. Checksum Sum 0x 48992
Number of opaque AS LSA 0. Checksum Sum 0x 0
Number of DCbitless external and opaque AS LSA 1
Number of DoNotAge external and opaque AS LSA 0
Number of areas in this router is 1. 1 normal 0 stub 0 nssa
External flood list length 0
Area 1
Number of interfaces in this area is 6
Area has no authentication
SPF algorithm executed 79 times
Area ranges are
Number of LSA 68. Checksum Sum 0x2218b0
Number of opaque link LSA 0. Checksum Sum 0x 0
Number of DCbitless LSA 1
Number of indication LSA 1
Number of DoNotAge LSA 0
Flood list length 0
Thanks
Best Regards