FWSM Route Mode Outside -- > DMZ

[victorm]

Hello,

I am running FWSM, in routed mode/single context.

I have an DMZ Interface.  I need a host to be able to access some servers on this Interface.

I've created a rule that will allow anything from this host into these DMZ hosts.

But traffic is not coming in.  I was reading the documentation, that not all traffic is allowed in Routed mode for the FWSM.

Any suggestions - I need this host to be able to see these 2 machines.

The machines are NAT'd, but I have created 1-to-1 NAT, and have also tried creating ACL on the Outside interface.

[Jon Marshall]

Victor

How does the host get routed to the outside interface of the FWSM ?

Are these machines on the DMZ able to communicate with other devices on the outside of the FWSM ?

Perhaps you could post the NAT and acl config ?

Jon