Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

FWSM- using object-groups in ACL

Can I use network object-group as source addrese(s) in ACL and just a network ( not a group) as target in the ACL ?

for example:

object-group network TEST

network 1.1.1.0 255.255.255.0

network 2.2.2.0 255.255.255.0

access-list MIX extended permit ip object-goup TEST 3.3.3.0 255.255.255.0

Is this conmfig supported in FWSM ?

2 REPLIES
Hall of Fame Super Blue

Re: FWSM- using object-groups in ACL

Yes this should work fine.

Are you having problems with it ?

Jon

New Member

Re: FWSM- using object-groups in ACL

I have not applied it yet, but going to apply to a live data center. Therefore I just want to make sure that there will not be any issues.

557
Views
4
Helpful
2
Replies
CreatePlease to create content