Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

FWSM version 2.3 some nat statements disappear after rebooting

SHOW RUN and SHOW RUN show all the commands as expected including all the nat statements. After reboot some of the NAT statements are not there. SHOW RUN and SHOW START doesn't have some nat commands

1 REPLY
New Member

Re: FWSM version 2.3 some nat statements disappear after rebooti

For example the last rebbot showed te following command was missing:

nat (cbd_pub) 0 access-list cbd_pub_TR

Althoug before the reboot SHOW START and SHOW RUN had this command.

It is not always the same command that goes missing, but they are nat commands.

118
Views
0
Helpful
1
Replies
CreatePlease to create content