Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM warning

Hi

I am getting the following error message on the FWSM module:

Router# hw-module module 9 reset cf:1

Device BOOT variable for reset = cf:1

Warning:Device list is not verified.

I am not able to find any information with regards to this, I take it that this is taking about the flash and not about the module?? does any body know how to stop this message??

Thanks MJ

1 REPLY

Re: FWSM warning

Hi MJ,

Yes, this message refers to the compact flash card and not the FWSM itself. As stated in the message, it is simply a warning that the FWSM software does not actually verify that an image exists in the location you set as your boot variable (i.e. you could set it to an invalid location and it would let you proceed).

In other words, the warning is nothing to worry about as long as you be sure to double check what you enter as your boot variable. I also did a quick search and found that the message is shown as part of the normal procedure when using the hw-module command (granted, it is an old version of documentation, but I couldn't find it in the newer versions):

http://www.cisco.com/en/US/docs/security/fwsm/fwsm11/configuration/guide/admin.html

Hope that helps.

-Mike

191
Views
5
Helpful
1
Replies
CreatePlease login to create content