Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSMs on 6513

Can the session slot ......command be used to navigate between different FWSMs in 6513?

4 REPLIES

Re: FWSMs on 6513

Hi ..

definetely .. you can connect to any module that allows interactive access using the session command .. do a show module and identify the slot your need to connect. If you need to connect to more than one module at the same time using the session command then you could have two separate remote sessions to the supervisor and from there open a session to every FWSM respectively

I hope it helps .. please rate if it does !!

New Member

Re: FWSMs on 6513

But the sh module is not working on FWSM...

New Member

Re: FWSMs on 6513

Aksher,

You could either use session slot x proc 1 or if you pull out the blade there is a hidden console on the blade. You could connect a serial cable to connect and get on the physical console of blade.

Hall of Fame Super Blue

Re: FWSMs on 6513

Hi

The show module command will not work on the FWSM. You need to exit back out of the FWSM to the switch then session to another of your FWSM's.

You cannot session from one FWSM direct to another FWSM as far as i know.

HTH

Jon

151
Views
0
Helpful
4
Replies