Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

General Security Context question.

Greetings All,

Is it possible to have the interface of two or more context on the same vlan?

For example context 1 has gig0/1.1 on vlan 10 and context 2 has gig0/1.2 on vlan 10 as well.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: General Security Context question.

Merrylle

Yes, contexts can use the same vlan. In fact this is a quite a common setup where the outside interfaces of the contexts are all in the same vlan and the dmz and inside interfaces are in separate vlans.

So you can have one IP subnet/vlan for all your outside interfaces.

Jon

1 REPLY
Hall of Fame Super Blue

Re: General Security Context question.

Merrylle

Yes, contexts can use the same vlan. In fact this is a quite a common setup where the outside interfaces of the contexts are all in the same vlan and the dmz and inside interfaces are in separate vlans.

So you can have one IP subnet/vlan for all your outside interfaces.

Jon

94
Views
0
Helpful
1
Replies