Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

get arp table on ASA using snmp

What is the way to get the arp table on an ASA using snmp? I tried doing an snmp walk on .1.3.6.1.2.1.4.22, which works on a Cisco router, but got nothing.

Thanks

Mike

3 REPLIES
Bronze

Re: get arp table on ASA using snmp

To view the ARP table, use the show arp command in privileged EXEC mode.The display output shows dynamic, static, and proxy ARP entries. Dynamic ARP entries include the age of the ARP entry in seconds. Static ARP entries include a dash (-) instead of the age, and proxy ARP entries state "alias."

Cisco Employee

Re: get arp table on ASA using snmp

what you are trying to accomplish in the ASA is not supported.

You already has configured SNMP on the ASA but it seems that there is no MIB that supports

to extract the ARP table and send it to that tool.

Here you have the link with the SNMP configuration and also there is a section that

indicates all the MIB supported, unfortunately there is nothing to obtain the ARP table.

http://www.cisco.com/warp/public/110/pixsnmp.html

there is nothing supported in version 7.x either, Checked the MIB

but nothin related with that.

http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chap

ter09186a0080565912.html

Please rate if helpful.

Regards,

Sushil

New Member

Re: get arp table on ASA using snmp

I was afraid of that. :) Thanks anyway.

1887
Views
7
Helpful
3
Replies
CreatePlease to create content