Anyone know how to retrieve the arp table of the ASA appliance via SNMP? For example, the command "show arp" provides the MAC/IP address of devices directly connected to the ASA. How can I retrieve this information via SNMP? I know how to do that on Cisco routers, switches and other devices such as Checkpoint & Juniper firewalls like this:
Hi David, I was briefly looking into this last night but I was not able to find OIDs for the type of MIB u want, in fact I wander if there is any, you can double look at MIB database located at http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml under Cisco Security & VPN products , there is one RFC1213-MIB but frankly perhaps not quite what you need.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...